|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
First of all I must say that I received the manual in just a few minutes after placing the order. The copy is well done and very readable. I will buy others soon... Thanks, Meyer
 ;
Good service manual. I gat all I want. Copy is good, but could be better. All clear and useful. I sincerely recommend.
;
The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.
;
Welcome. The scheme is clearly helped me to repair. Worth to download it.
;
Excellent manual, very clear, technical specification provided, useful information regarding adjustment and set up.
Power
Amplifier
BPX1100.1
Features
2-Channel Operation Advanced MOSFET Oversized Floating Rail Power Supply Floating Ground Factory - Head - Unit Speaker - Level input Variable Input Sensitivity (250mV - 6V) Fully Complementary Output Stage with Class-D Voltage Amplification Gold-plated Power, Input and Output Connectors 1-Ohm Stable ( 2 ohm parallel )
Test Conditions and Notes
All tests to be done, unless otherwise specified, from 20Hz to 320Hz at 14.4V DC into 2 ohm loads and will be done using an Audio precision system one and the supply voltage.
the units gain so that with a .775 volt input signal the unit is at its maximum rated output. All meas
An A+ line voltage of 14.4V DC shall be applied to the unit under test for all measurements unless oth
specified. The voltage applied to the unit shall be measured at the power connection on the Amplifier. Signal Source
Unless otherwise specified, all tests shall be conducted with the Audio Signal Generator output config connected to the Amplifier PWR GND at the Amplifier. Output Load
be balanced, less than or equal to 50 ohm source impedance, and floating. The signal source "GND" shal
Unless otherwise specified, all tests shall be conducted with 2 ohm resistive loads having less than 1 while dissipating the rated output of the unit under test. Power Indicator LED steadily illuminates for normal operation. LED blinks when protection circuitry is engaged, and during power up.
reactive components at any frequency below 350Hz. Each resistor shall have a value that remains within
2
|
|
|
> |
|
